snapchris 0 Posted August 27, 2012 Windows 7 Flexisign 8.1 & Tried SignCut Drivers from the website Serial Connection Grounded to stand Blade barely sticking out I just received my new SC cutter, hooked it up and tested it. Speed 400 and force at 100. It cuts nothing in the vinyl. The blade isnt even close to the vinyl. If I adjust the force to 600 it drags the blade and cuts very uneven. Real deep on one side and nothing on the other end but it still leaves drag marks. Any other settings, I either get no cut in the vinyl or the same uneven cuts. Could there be something wrong with the blade arm not going up and down? It doesnt seem to move up and down at all. Ive tried everything that I can think of. Please help! Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted August 27, 2012 answered on other post. No need for duplicate posts. Share this post Link to post Share on other sites
snapchris 0 Posted August 27, 2012 my bad.tried to delete and couldnt. Share this post Link to post Share on other sites
