Sign in to follow this  
fragged8

line appearing ??

Recommended Posts

hiya

please could some kind soul check this for me as it's driving me nuts AHHH!!!

I have looked over the wireframe and cant find anything wrong, in Corel x4 the wireframe looks good

but when I save the file and then import into Signlab a line appears from one side to the other side which then gets cut.

I have circled where the odd line appears in signlab but as you can see there isn't one in corel.

Could it be a white line or transparent ?

kind regards

Rich

complete BW logo error.ai

post-3735-0-62939600-1345760083.jpg

Share this post


Link to post
Share on other sites

see if you can get this file to work. There were 2 lines there, I cut them.. Each of those sections had a line going across it.

Thank you very much Mz SKEETER

it opens in signlab fine now, any ideas why I couldn't see them in corel ? i spent ages

looking for lines there .

Thanks again

Rich

Share this post


Link to post
Share on other sites

Thank you very much Mz SKEETER

it opens in signlab fine now, any ideas why I couldn't see them in corel ? i spent ages

looking for lines there .

Thanks again

Rich

Your welcome. I don't use Corel, but I didn't have any problem seeing them at all in Flexi software. on wireframe...

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this