bagmania01 0 Posted August 5, 2012 Hello.. I've had a Refine MH721 for about 3 or 4 years and just now starting to get a little serious about using it. The problem I have is that I never know when the plotter is just going to start cutting or roll the vinyl back and then start. How do I tell what it's going to do, or what do I need to do to make it do one or the other Thanks for any help you can give me. Thanks Rick Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted August 5, 2012 Did you set orgin ? And welcome Dan Share this post Link to post Share on other sites
slice&dice 2,450 Posted August 13, 2012 Press RESET. Share this post Link to post Share on other sites
velocitygraffix 8 Posted August 20, 2012 try looking at your start and finishing points. you might have something in your que, or might try the button on the plotter that make's you start cutting from that point. Share this post Link to post Share on other sites
