Recommended Posts

Hi guys i am using a ct630 ( USB port only on the cutter ) and a laptop with windows 7. I have assigned ll the ports ect on the comp and in signblazer. However sometimes the image says sending and the cutter does not respond, but then others it will work fine. When the cutter is off it still says its sending the image :huh:. Also the cutter head when cutting sometimes stutters ( Jerky ) but still cuts the image ok. Is this down to the usb to usb lead? Would i be better with a desktop set up and use a serial port to the usb port on the cutter?

Hope this makes sense.

Thanks

Share this post


Link to post
Share on other sites

Yes better to use serial port on the lower end cutters, a serial adapter might help. Or possibly your USB cable is too long, you can try changing it

to a shorter cable.

Share this post


Link to post
Share on other sites

thanks for the reply i have changed the cable. So if i set up a desktop and the get a serial that has the usb end on for the cutter this should work better ?

Share this post


Link to post
Share on other sites

So your Pcut does not have a serial or parallell port? only USB is that correct? Is it a newer Pcut?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now