Trumpy 5 Posted June 8, 2012 This is probably a simple thing but it’s driving me nuts. I have a Graphtec CE5000-60. I am using Corel Draw x4 with cutting master. I load my vinyl, press enter, and after it measures the width, the cutter moves to the very front right corner. After the cut, I have it advance 2” so I can use the cutting trough (I hope that is what that slot is for.). Now I want to cut another design with the same vinyl. How can I get the cutter to go back to that very front right starting position without raising the pinch rollers and starting all over? I hope this makes sense. Thank you. Al Share this post Link to post Share on other sites
arty-rc 719 Posted June 8, 2012 Just backfeed the vinyl, hit the origin button and then enter. Share this post Link to post Share on other sites
Trumpy 5 Posted June 8, 2012 That’s what I do; I just thought there was a setting or a button that would take it back automatically. Thank you for your reply. Al Share this post Link to post Share on other sites
Jay2703 704 Posted June 8, 2012 Mine isn't a Graphtec, but if I hit my Origin button two times it will re-index my vinyl. Share this post Link to post Share on other sites