Dotted lines when a cut to the right

Recommended Posts

I know there have been other discussions here around this and I have read through all of them. I am still experiencing the same problem which is that any cut going to the right (whether it be a straight line to the right or a diagonal to the right) is leaving a dashed line in the cut. All other directions are nice clean cuts.

This is a new occurence and never used to perform like this. Please let me know what may be causing this, what needs to be done. It is still under warranty if that is the case.

Thank you,

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now