Dr12volt1338 116 Posted May 23, 2012 This is just the inner door I am going back tomorrow to do some stuff on the out side of the building. The customer supplied me the fox she wanted to use. I printed that on Mactac with my DesignJet 800. The lettering is Oracal 651 (Burgundy) and Greenstar (Gold). I will post the rest tomoorow after they are done. I don't know what the specs are at the top they only appear in the picture. 1 Share this post Link to post Share on other sites
Jay2703 704 Posted May 23, 2012 Great design. Did you create it? Share this post Link to post Share on other sites
Dr12volt1338 116 Posted May 23, 2012 I did all the layout and picked the font. She provided me with a horrible picture she took with her flip phone of the fox. I had about 5 hours cleaning it up. I changed it a little but for the most part I can't take much credit for the fox. The Donut I am putting up tomorrow I did more with. Took a real basic wire frame design and tweaked it to what I wanted in my head. I will post those tomorrow when I go put them up. I printed that fox even though I did vectorize it so I can cut if that doesn't hold up. Everything I do tomorrow is cut and layered kind of curious how it is going to turn out. Share this post Link to post Share on other sites
Ballistic 28 Posted May 23, 2012 The fox looks awesome!! :thumbsup: Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted May 23, 2012 Great work Dan Share this post Link to post Share on other sites
jhumbeutel 1 Posted May 23, 2012 Did you put that on the outside of the glass or the inside? Looks great! Share this post Link to post Share on other sites
Dr12volt1338 116 Posted May 23, 2012 Its on the outside. I never install to the inside unless the customer absolutely insists. Share this post Link to post Share on other sites