billj 0 Posted April 28, 2012 i cant get my ve r31 cutter to work with my other software ( dr stika ,corel draw ) i tried finding the driver put its not listed in windows i contacted signwarehouse and they said is dos based is there any way to us it other than with lexi of flexi software . Share this post Link to post Share on other sites
Dr12volt1338 116 Posted April 28, 2012 There is a plug in you can download for Corel Draw but I can tell you from experience with mine the only way to go is to use it with a serial connection with the LXi or Flexi. You can do your design in Corel and export as a .eps and import it into LXi to cut. I have had mine for over a year and went round and round with it and the usb driver.... It is by far the worst USB driver I have ever dealt with. Even trying to use the actual Redsail drivers make it near impossible to work with... Been on a serial connection for about 6 months and 100% problem free. Share this post Link to post Share on other sites
AbsoluteAirbrush 33 Posted April 28, 2012 +! on that Dr, I was in the same boat until I went serial, only way to do it in my opinion, althought I use signblazer now. Share this post Link to post Share on other sites