CP-2500 Blade Problem

[ohiovalleygrafx 0]

I got a 2500 a couple months ago and recently when I cut out a design its not completing the cut. It like the blade is jumping around cause it to perforate the cut instead of a clean cut. If I change the blade it cuts fine for awhile then it starts doing it again.

anyidea why its doing it? It change the pressure and speed also to see if it would stop. I didn't.

[tonyfatz9 0]

Check blade depth or change blade.

[ohiovalleygrafx 0]

I've checked the blade the blade depth and changed the blade. New blade will work fine for about 15 min then it starts it again.

[360_Media 1]

This seems very unresolved... there are many posts explaining this problem and none I have seen are resolved. What's going on? Are people just dissappearing and figuring it out themselves or giving up and selling their Copams?

[Dakotagrafx 7,297]

usually caused by too much blade depth and/or damaged cutting strip