Recommended Posts

I've had my MH721 for about 3 years and it has been a real workhorse for me. Just today, when I turned the unit on, I noticed it sounded a little different than usual. When it cuts, everything works at proper speed until it starts to do a diagonal movement and then it slows down. Cutting is still perfect but the slowness is a little bit of aggravation. Any ideas on what the trouble is? (ps-I went to the setup screen and changed both movements to "Normal") Thanks in advance for your help. David

pss-Sorry, I posted this yesterday in the wrong place. IQ was low from getting up too early.

Share this post


Link to post
Share on other sites

I have some files do that with my Copam , does it do it on all files ? . I think it is just the way the software reads some files .

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now