donnaredd 0 Posted April 17, 2012 I am using Roland PC-60 and FlexiSign Pro 6.5v3. After much trial and error I have finally gotten my laptop to recognize the parallel to USB connection. I have downloaded Roland driver and the software shows Roland. I import a purchased download of a rhinestone design (EPS) into Flexi and parse the postscript. I send it to the Production Manager thru Flexi and it processes from 0 to 100% using COM3 port......but the cutter never cuts!!!! I have checked mode in command prompt-it shows: Status for device COM3: Baud - 115200 Parity - None Data Bits - 8 Stop Bits - 1 Timeout - OFF XON/XOFF - OFF CTS handshaking - OFF DSR handshaking - OFF DSR sensitivity - OFF DTR circuit - ON RTS circuit - OFF Flexi has cut these designs on my brother's Roland CAMM 30" following this procedure - has to be setting errors - please help - I want to throw it out the window! I have a lot invested in downloads I can't cut or use. Donna Redd Share this post Link to post Share on other sites
mopar691 281 Posted April 19, 2012 using com port with parallel cable will not work. change it to the correct port. Share this post Link to post Share on other sites