inksane

How to replace power supply on ct-630

Recommended Posts

My power supply just crapped out on me today so i ordered a replacement should be here in a few days, i just wanted to know if anyone could tell me how to replace it. i have never opened the unit up.

Thanks,

Kyle

Share this post


Link to post
Share on other sites

I am sure its very simple once you get the main cover off should be pretty self explanatory to remove once you have it tore down to that point. It may even come with some directions. Make sure you are static free as you are touching the circuit boards and what not inside the machine.

Share this post


Link to post
Share on other sites

I think I read somewhere that in order to get to the power supply, you turn the cutter on its side and remove the 8 screws on the bottom, and the power supply should

be visible once you remove the panel. Then you should be able to figure out how to remove and replace the power supply once you see it.

Share this post


Link to post
Share on other sites

When removing the panel only take out the 8 screws on the sides of the bottom, the screws on the very bottom remove components and they will fall. ( you can imagine figured this out)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now