kemalloy 0 Posted April 3, 2012 Just upgraded to flexi starter 10 from signblazer thinking it would be a better program to cut with, HOWEVER, I am going crazy. I can not figure out how to get it to cut my vinyl. I have looked on youtube with no success trying to find some kind of instruction manual. Can anyone tell me where is a good place to learn how to use this software. Share this post Link to post Share on other sites
Dr12volt1338 116 Posted April 3, 2012 set up your design. click on the cutter at the top, set up the production manager IE cutter make, model and port, the production manager will pop up minimize that. There will be a smaller screen left open that shows your design on it click the send button at the bottom of that. Share this post Link to post Share on other sites