MFPIRAINO 0 Posted March 26, 2012 I have a Mh721 cutter and I am trying to find some tips on cutting Tackle Twill. Are there certain settings for Tackle Twill? Share this post Link to post Share on other sites
lueman 19 Posted April 1, 2012 I have the lp24. Tackle twill is difficult because of the cross fibers, they almost never cut cleanly. I always use a new 60deg blade, slow speed and a high down force usually around 180! and even then it doesn't always cut clean. Note down force should just be strong enough to cut the material not the carrier substrate. some time I lower the down force and run 2 copies over each other. I love the lp24 but twill is really hard on it. Share this post Link to post Share on other sites