kimbalee 0 Posted February 3, 2012 Just curious since my software freezes during a job. Is there any way to salvage a cut or know where to put the cutter back to cut back over a job. I hope this makes sense. Didn't know if it was possible. Thanks Share this post Link to post Share on other sites
Rodger 527 Posted February 3, 2012 I have resent the job back to the cutter & had no double cuts many times , other times have to start again . Worth a try IMO . My cutter auto measures the vinyl . I have not had that problem after going to a serial cable though . I have read some of the cutters have additional memory available ( lack of memory on big jobs cause that peoblem sometimes ) Share this post Link to post Share on other sites