Sign in to follow this  
drumnow

Pinch Roller Installation

Recommended Posts

Hello,

I purchased 2 additional pinch rollers in an attempt to limit the amount of drift I am experiencing.  I run it out the full length of the cut before dropping the knife and it doesnt drift at all, but as soon as I start cutting it goes absolutely crazy.  So, I figgure that the rollers arent holding it tight enough against the friction of the knife.  I need instruction on installing these additional rollers.  I have looked for instructions for about 30 min and I am now asking the list for assistance.

Visual instruction would be nice, but I will take anything at this point before I dig into this.

I have the pcut 630

Thanks

mike in NE PA

Share this post


Link to post
Share on other sites

Looking at the back of the PCut on the right side you will see a screw that stops the pinch rollers from going all the way to the right. Remove the screw, and then you can move the pinch roller all the way to the right to remove, or add additional rolllers.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this