livingagain75 0 Posted July 19, 2011 I have been having a hard time with the vinyl falling off of the rack during the cut. It seems that if I don't pull enough slack to make the cut the roll will fall off. It used to be able to roll out as need be. Has anyone else had this problem? Share this post Link to post Share on other sites
AshComputers 197 Posted July 19, 2011 I always give my vinyl slack, dont want the extra pull on the rollers Share this post Link to post Share on other sites
Rodger 527 Posted July 19, 2011 How fast you have the speed set to & how it advances ( ex; straight line cuts ) will cause problems if you don't have more vinyl pulled off the roll than you are cutting . IMO always have more length of vinyl pulled off the roll than the length of the decal . Share this post Link to post Share on other sites
livingagain75 0 Posted July 19, 2011 The last cut imade was on premium plus so the speed was at 30 and it still pulled off. I'm not really worried when doing a small to mid size decal. But am worried about 50 - 70 " cuts. I guess I will just have to keep the slack free. You know know that I think about it, that is what I did before. I will have to post the job I did to my Mustang... Share this post Link to post Share on other sites