Sign in to follow this  
craigasian

Mac with MH-721 "HOLDING"

Recommended Posts

I had setup my Mac with this cutter before but then had the hard drive crash and I had to re-install everything, My problem. This time, everytime I start cutting it will barely cut and then say "HOLDING" any idea's this is driving me nuts

Share this post


Link to post
Share on other sites

I had setup my Mac with this cutter before but then had the hard drive crash and I had to re-install everything, My problem. This time, everytime I start cutting it will barely cut and then say "HOLDING" any idea's this is driving me nuts

Check your software settings, I remember seeing an option somewhere for signcut or cuttingmaster that says "hold on color" where it waits for color switches to send the cut commands

Share this post


Link to post
Share on other sites

Download the latest drivers here if you are on USB: http://www.ftdichip.com/Drivers/VCP.htm and here if you are using a Kayspan: http://www.tripplite.com/en/support/downloads/index.cfm?txtArchive=0&txtLang=&txtOS=

Make sure your baud rate is also up... I believe 9600...

Can't think of anything else right now since I'm not sitting in front of it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this