quvmoh 1 Posted July 11, 2011 Howdy all, Been away from the forums for a while. about a thousand years ago I researched going full Linux in my shop and was mostly successful except for communicating with the cutter "refine 721". After a hardware issue on the Windows box feeding the cutter I decided to search again http://inkcut.sourceforge.net/ I set it up on Ubuntu 10.04 and was able to cut a path directly through the USB port, something I was never able to get working in Windows even with the nifty driver "not a slam on Windows ". Was so excited I needed to pop on and show my first cut :-) 1 Share this post Link to post Share on other sites
capross 1 Posted July 26, 2011 Howdy all, Been away from the forums for a while. about a thousand years ago I researched going full Linux in my shop and was mostly successful except for communicating with the cutter "refine 721". After a hardware issue on the Windows box feeding the cutter I decided to search again http://inkcut.sourceforge.net/ I set it up on Ubuntu 10.04 and was able to cut a path directly through the USB port, something I was never able to get working in Windows even with the nifty driver "not a slam on Windows ". Was so excited I needed to pop on and show my first cut :-) Awesome, I just switched over to a linux distro and am looking into getting my mh721 working now. Hope everything is working out! 1 Share this post Link to post Share on other sites