ttik 0 Posted June 30, 2011 I am facing this problem (see attached), see those three spots in the picture. What is the problem causing that and how to solve that problem? ***all other lines are perfect without alignment issue, only those 3 spots i mentioned. using pcut cs1200 , flexisign 8.6v2 , win 7 Share this post Link to post Share on other sites
vinylmotivations 143 Posted June 30, 2011 Couple things.... What is your offset set at? Should be .15-.25ish.... and speed?> You can't set it at max speed and expect accurate results. Slow her down to a much slower setting and see if she still jumps around. Also may be a driver/compatibility issues. Flexi 8 Isnt compatible with Windows 7 and will sometimes give you mixed results.... Share this post Link to post Share on other sites
ttik 0 Posted July 3, 2011 thanks for your advice. i am using 60deg blade and the blade offset set to around 0.180 (best result for me) and the cutter speed set to 30 (lowest speed) also i installed the updated win7 usb driver for flexi 8. i will test it again with my flexi 8 on win xp. Share this post Link to post Share on other sites