Sign in to follow this  

CS1200 manual feeding alignment out

Recommended Posts

Hi guys,

I've attached Book1.pdf here and I'm not sure how to confirm the manual feed is out or not.

As you can see in the pdf, I drew a few marks so that I can positioned them on my machine.

Initially, I adjusted it to 2mm on the right.

When I roll the paper out till it reaches 1700mm, the paper seems to shifted to right hand side about 0.4mm.

Then returning back to 0mm where I was started, now shifted to right hand side about 0.1mm compare to 2mm(initial where i started).

I am not sure I am doing the correct way to confirm the paper is skewed which will cause alignment out cutting.

Which I am facing like attached Book2.pdf

Kindly advise. Thanks



Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this