dabagman7 0 Posted May 12, 2011 can anyone please help me getting peed off. i have a goldcut 721 and im using signblazer i have everything set up correct i think but no matter what vector i try and cut even the factory one it wont cut it all. like the details of the pinkpanter logo. i cant figure it out i have been using this thing for hours i just cant get it to cut my whole project can someone help Share this post Link to post Share on other sites
towman208 38 Posted May 12, 2011 are you going to edit and selecting all then go to arrange and cobining it Share this post Link to post Share on other sites
BearlyRich 167 Posted May 12, 2011 In the cut screen, on the top left corner, are you selecting all the colors? Share this post Link to post Share on other sites
dabagman7 0 Posted May 12, 2011 ok im tryin to just cut the fire sign i did the select all combin still cuts only half the flame. and please tell me again how to select yall colors im a newbbie. Share this post Link to post Share on other sites
mr300s 1,272 Posted May 12, 2011 ok im tryin to just cut the fire sign i did the select all combin still cuts only half the flame. and please tell me again how to select yall colors im a newbbie. After the cut window comes up on the left side hold down the ctrl button on all the colors hten they should appear in the window and ready to cut Click on the yellow arrows on the left so the x is gone while you hold down the ctrl button If you don't need the colors seperate you can click on it go to the top tool bar click on arrange then click on combine and then you dont have to worry about it Share this post Link to post Share on other sites