SignLadyNC 0 Posted April 27, 2011 This machine tracks, and goes off up to a quarter of an inch over about 6 feet. Sometimes when cutting, it will decide to go off and track further on down, and when it comes back, it has gone off track and it is driving us nuts. Nothing comes back to the right place and ruins almost 50% of our work. This cannot go on! HELPPP! Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted April 27, 2011 when you are doing your job, do you have enough vinyl pulled free from the roll, so that it is never pulling directly from your vinyl roll while it is cutting? Pulling directly from the vinyl roll can shift your vinyl. Doesn't that machine have a prefeed feature to prefeed your vinyl before cutting? Share this post Link to post Share on other sites