jtrennepohl 0 Posted March 30, 2011 I have a pcut and i just started cutting today i cut out 3 items for a job and i went to start cutting again and nothing happens signblazer says it went to the cutter but nothing cuts please help Share this post Link to post Share on other sites
AshComputers 197 Posted March 30, 2011 E-mail me Jason... tech@ashcomputershop.com Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted March 30, 2011 I have a pcut and i just started cutting today i cut out 3 items for a job and i went to start cutting again and nothing happens signblazer says it went to the cutter but nothing cuts please help I am guessing you are using USB, because you never stated, So did you after cutting the first order, by any chance unplug the USB cable and plug it back in? More info. Have you tried rebooting your computer? What exactly have you done. Is there a time between these first cuts, then you just turned your cutter back on and started another job? Need more info. Share this post Link to post Share on other sites
prestonservco 26 Posted March 30, 2011 Did you press any buttons on the cutter? Offline, Pause, etc. Share this post Link to post Share on other sites