Contour cut offset issues

[TomasB 23]

I'm running into some difficulty with the contour cut again, after finally getting it to cut it has an offset that I don't know how to adjust . It seems that the y-axis is off. I'm using SignBlazer on a LP24. Any help would greatly be appreciated.

Thanks

TomasB

[AshComputers 197]

I'm running into some difficulty with the contour cut again, after finally getting it to cut it has an offset that I don't know how to adjust . It seems that the y-axis is off. I'm using SignBlazer on a LP24. Any help would greatly be appreciated.

Thanks

TomasB

Look here http://forum.uscutter.com/index.php?/topic/31236-contour-cutting-tutorial-signcutprod-pro-and-the-lp24/

[TomasB 23]

Look here http://forum.uscutter.com/index.php?/topic/31236-contour-cutting-tutorial-signcutprod-pro-and-the-lp24/

Thanks Ash

But I'm using signblazer. Might you have a link thats specific to SBE?

[AshComputers 197]

Thanks Ash

But I'm using signblazer. Might you have a link thats specific to SBE?

Look here http://forum.uscutte...o-and-the-lp24/

and here http://forum.uscutter.com/index.php?/topic/10739-laserpoint-x-y-calibration/page__p__119148__hl__%2B%2A%2Asb+%2Boffset+%2Blp24__fromsearch__1#entry119148

You can set it on the cutter, not the software. Let me know if this helps ya or not

[AshComputers 197]

If your contouring http://forum.uscutter.com/index.php?showtopic=2901

[TomasB 23]

Thanks Ash