BBOwen 0 Posted February 11, 2011 I am not getting sharp 90 degree corners. Has a new blade too. What might be causing that? Cutting pressure 110. Share this post Link to post Share on other sites
Jay2703 704 Posted February 11, 2011 Check your offset. Share this post Link to post Share on other sites
BBOwen 0 Posted February 11, 2011 It was at 0 but I bumped it up to 20. The corners aren't much better but I not getting the little incomplete cut tags that were left but the cutter before? What does everyone else keep their offset set on? Share this post Link to post Share on other sites
cutme 5 Posted February 11, 2011 .25 is the standard. and if you take the left end housing cover off, you may find some slack in the feed roller drive belt. adjust the slack out and you will get better cuts. bb Share this post Link to post Share on other sites