b12yan12

MH721 problem, blade not lifting, z-chip?

Recommended Posts

20 minutes ago, Kelmo66 said:

I Give up.  Replaced the Mother Board also and blade still will not lift up.

 

 

could be a bad solenoid in the carriage - can test with a 9 v battery as described elsewhere in the forum
by the time you chase it down you will have spent a good amount toward a sc2 - much better cutter IMHO

Share this post


Link to post
Share on other sites
24 minutes ago, Kelmo66 said:

I Give up.  Replaced the Mother Board also and blade still will not lift up.

 

 

if solenoid then the entire carriage is only $32

pretty impressive you got the mainboard next day

Share this post


Link to post
Share on other sites

I agree probably a good idea to upgrade now.  I did replace the entire carriage with the solenoid.  US cutter techs are helping me trouble shoot further but I'm currently looking into another cutter.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now