trex 0 Posted October 31, 2006 I have Flexi Sign Pro 7.62 Share this post Link to post Share on other sites
thredz 1 Posted October 31, 2006 I'm not positive,but I think you can use the roland pnc1000 driver.I think it's more or less the universal driver for these cutters. Bill Share this post Link to post Share on other sites
MarcelC 5 Posted October 31, 2006 That is absolutely correct. If there is a Refine driver like in Artcut you can use the REFINE MH721 DMPL driver, other wise the Roland PNC 1000 works just fine. Share this post Link to post Share on other sites
davefox 0 Posted December 12, 2006 I used the parallel, then the USB, and finally went to the serial port and the plotter fired right up on the Roland driver for the PNC 1000 on COM1. I am running FlexiSign Pro 7.5 and it cuts flawlessly. Like all small cuts, weeding is a real pain. Corners are almost always stuck together on the high performance 2mil products. Even with the appropriate boxes checked on the cut properties dialog box. Share this post Link to post Share on other sites