Alillowr 0 Posted December 16, 2010 Ive got a vector that I would like to cut but I don' know how to make the crown with the lettering merge together with the top of the figure without having a cut mark where the figure is. Attached is the eps which was edited in illustrator, and I am using Flexi to cut. test.eps test.eps Share this post Link to post Share on other sites
Jay2703 704 Posted December 16, 2010 It depends on what program you are using. If you are using SignBlazer, you would select both the crow and person then select Arrange + Weld + Total Weld. Jay Share this post Link to post Share on other sites
Alillowr 0 Posted December 17, 2010 I amy uding flexible. I tried welding but it isnt working right. Thanks for the idea though Share this post Link to post Share on other sites
Alillowr 0 Posted December 17, 2010 Flexisign not flexible (auto correct on the phone) Share this post Link to post Share on other sites
Jay2703 704 Posted December 17, 2010 Here you go. Did some cleaning up of extra stuff then did the weld. test1.EPS Share this post Link to post Share on other sites
Alillowr 0 Posted December 18, 2010 Thank you very much for that. What program did you use for this and how was it done? Share this post Link to post Share on other sites
Jay2703 704 Posted December 19, 2010 I used SignBlazer and just removed un-necessary stuff then did some welding and combining. Share this post Link to post Share on other sites