CT-630 Installation

[Streetkarnage 0]

Hello everybody.

I purchased my first vinyl cutter yesterday, It is a CT-630 and I got it 2nd hand.

The only thing is it didn't come with an installation disk, I have been searching for a driver software for it but have failed.. but this forum kept popping up so I decided to join up and ask.

So what I'm getting at is I don't know how to get the plotter to show up in my drivers. haha

Thanks in advance.

Zak.

[Streetkarnage 0]

and I think i just posted this in wrong section :facepalm:

[Dakotagrafx 7,297]

http://support.uscutter.com/index.php?_m=downloads&_a=viewdownload&downloaditemid=30&nav=0,4

[Streetkarnage 0]

Thank you.. Looks to be working so far haha

[Streetkarnage 0]

It has come up with an error once I have clicked cut tile.

this is what is says:

Can not open the output device. Error initializing cutter

[CRD 9]

http://forum.uscutter.com/index.php/topic,17489.0.html

[Streetkarnage 0]

Thanks for that, helped with a lot of things.

Im still geting the error though, I select the output device LTP1 (If I select any other device it instantly comes up with the error) it comes up with a little window saying "sending output to Cutter" it stays on this for about 5mins then the error pops up.

[Streetkarnage 0]

well still cant get it to work

it defiantly connected to LTP1.

Is there any driver software I am meant to install before SignBlazer?

[Dakotagrafx 7,297]

well still cant get it to work

it defiantly connected to LTP1.

Is there any driver software I am meant to install before SignBlazer?

I don't remember my p-cut having a parallel port

[Zero Degree 0]

are you connected with a serial port or usb?

[CRD 9]

Place a picture of the connectors ON the plotter not the pc.

Paco