neron15210 10 Posted November 25, 2010 I'm in need of large cutter (54") with capabilities to read reg marks . Considering to buy ZenCut but I can not find enough info about it. If anyone can give me some pointers about this machine I would appreciate it. thanks D. Share this post Link to post Share on other sites
roxanneupnorth 106 Posted November 25, 2010 Zencuts are rebranded GCC cutters.......Not sure whether or not the specs are exact or not..... Share this post Link to post Share on other sites
neron15210 10 Posted November 25, 2010 That is my concern. Anyone here using this machine willing to share some info? thanks Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 25, 2010 seems most people use the Gcc drivers as the softwares don't list the zens. Read a little about issues with macs, other than that a couple of people said they liked them but haven't seen a review from someone with a lot of experience with different cutters yet. Share this post Link to post Share on other sites
neron15210 10 Posted November 25, 2010 Good tracking and recognizing printed reg marks is what I'm looking for (new graphtec is a bit to0 much for me right now) Share this post Link to post Share on other sites
roxanneupnorth 106 Posted November 25, 2010 2500 for a 54 inch Zencut Green versus 3200 for a 48 inch Graphtec.....Do you need the extra 6 inches?.....For 600.00 extra unless I needed the 6 inches the Graphtec seems to be a no brainer..... Share this post Link to post Share on other sites
neron15210 10 Posted November 25, 2010 Media i stock is mostly54" wide. Any cutter which can accept That width would work Also where did you find 48" graphtec For $3200? Share this post Link to post Share on other sites
roxanneupnorth 106 Posted November 25, 2010 US Cutter...... Share this post Link to post Share on other sites
neron15210 10 Posted November 25, 2010 Thanks They also have one 64" refurbished for $3490. Have to call tomorrow to Check on shipping costs. Graphtec is graphtec. Share this post Link to post Share on other sites
neron15210 10 Posted November 26, 2010 Thank you all for your help. I just purchased Graphtec FC 7000-160 64" from US cutter. It should be here by the end of next week. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 28, 2010 congrats on the new cutter to go with the new printer (I said with great envy) Share this post Link to post Share on other sites
neron15210 10 Posted November 28, 2010 Thanks Scott. Share this post Link to post Share on other sites