Sign in to follow this  
grafixcity

ecocut giving trouble

Recommended Posts

I just got my ecocut last week and I have been trying to learn it. It started out fine now it does not complete the cuts and today it started reseting it self in the middle of a cut

I am using sign cut and inkscape with usb

Help ;D

Share this post


Link to post
Share on other sites

Make sure your cutter is properly grounded. Also, are you running from laptop or desktop? USB is not very reliable. If you're using desktop, DO NOT use the front USB ports. Or use an externally powered hub. You may also want to invest in keyspan.

For cuts not completing, is it stopping in the middle or the endpoints aren't matching. If end points not matching, then you need to adjust your offset.

Share this post


Link to post
Share on other sites

Thanks I am having the power problem with the laptop and usb

as for the cuts it is just not making all the cuts it may skip one side of a letter

Share this post


Link to post
Share on other sites

I have an EcoCut as well and had loads of trouble with SignCut. Try Signblazer instead, it made a huge difference for me and saved a lot of headache.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this