sayitanywhere

SCPro Help

Recommended Posts

My subscription for SignCut X2 just expired, and I was looking at upgrading to SignCut Pro.  I downloaded the trial and tried to cut something.  Ihave it set up through COM2, and when I select cut the cutter responds, but doesn't cut the image I gave it.  The blade just runs all the way to the other side of the cutter and continues to run even when it runs into the side of the cutter.  ?!  I have no idea why it is doing this!  I restarted both cutter and computer.  The renewal price for SigncutPro is much better for me than the 1 year price for X2. 

I have the Refine 721.  It worked just fine until my Signcut X2 expired.

THANKS!

Share this post


Link to post
Share on other sites

to closing the programs and opening again and shutting off the cutter and turn it back on.  Or try to uninstall the programs reboot and reload and go from there I have done that in the past and it has fixed problems.

Share this post


Link to post
Share on other sites

Power off cutter, unplug USB or serial cable, let sit for about 30 seconds. Power cutter back on, plug in cable, send your job again. That will allow the cutter's memory to reset and that may resolve the issue.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now