kpsxtyone 0 Posted September 23, 2010 Hi, I got the cutter for just over 6 months now. It has been great till i used it again after a month of idle. I normally cut at 70 with pressure of 130 on a 45 degree blade for simple outline decals. When i tried cutting with the same file it the end cut are not matching. I have to cut it at 50 and it will work just fine. This also affected contour cutting. for a 8 x 11 paper with say 6 circles (2 columns x 3 rows). The ones closest to the front of the cutter are perfect middle is a bit off then the last one is not acceptable. I was wondering if the motor, gears, belts need replacing after say... 100 hours of work?(with in a span of 5 months). Do i take it apart lubricate the bearings and double check any clearance? Thanks, Ryan Share this post Link to post Share on other sites
Jay2703 704 Posted September 23, 2010 They are pretty much maintenance free. Just keep the dust off and throw a new blade in now and then. Share this post Link to post Share on other sites
cutme 5 Posted January 31, 2011 if you remove the cover off the end of the cutter that has the power switch. you will find a belt that is likely a little loose. you can adjust the tension on it and your cuts will improve. bb Share this post Link to post Share on other sites
designali 0 Posted June 25, 2013 how can i get info on where to adjust the tension. any pics? Share this post Link to post Share on other sites
skarekrow 1,842 Posted June 25, 2013 QUOTE> how can i get info on where to adjust the tension< I think you just did... Share this post Link to post Share on other sites
Country Junkee 6 Posted November 20, 2013 Omg I am in the middle of a job and my laserpoint just went crazy! All it does is goto the end and bump back and fourth not recognizing any wrk tjat was sent do u know what is going on??? Share this post Link to post Share on other sites
