spdas 0 Posted September 14, 2010 Aloha, all. I have only a USB on my laptop, using XP on the PCut 630. When plugging in the "online" Cutter I do not get the typical "install screen" prompting me for drivers. I installed the USB drivers from uscutter site. When I plug in the cable I see Comm14 being requested in the Device manager, but the Comm3 is in use by something else on my laptop. What to do? thanks Francis Share this post Link to post Share on other sites
CRD 9 Posted September 14, 2010 If com4 (not com14) is in the device manager hooked you have to set the cutter program to the same port. See newbie manual in instructional section. Paco Share this post Link to post Share on other sites
spdas 0 Posted September 14, 2010 Aloha, and thanks, that got it. I could not find the settings button for the life of me. and there it was in the "go to cut menu". Seems to work now. thanks again Francis Share this post Link to post Share on other sites
