brewzer1818 0 Posted September 9, 2010 I just recently switched to a new computer. got everything hooked up using a usb to serial cable. Windows 7 machine no serial port. running signblazer settings Blazer com3 prolific usb to serial Baud 9600 data 8 priority none stop bits 1 Flow controll hardware cutter cuts great when it cuts but will only cut every third or fourth time that it is given the command, otherwise shows connecting but nothing hapening. had to replace motherboard about two years ago and everything has been fine since. overall very happy with cutter would like to just fix current problem. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted September 10, 2010 I would try another usb cable Share this post Link to post Share on other sites