jmatson 2 Posted September 4, 2010 I have been trying to figure out the best way to make small detail cuts. Of images. where the lines are close together. I have slowed my speed down to 20. but that still don't work some times. It peels up in the middle of that cut Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted September 4, 2010 main thing is to have the absolute least amount of bland out possible. back when the founder of signblazer was alive he recommended less blade more pressure!. you can get a p-cut dialed in pretty good with enough effort. but in the long run make the money with the p-cut and buy a graphtec or roland. I have had p-cut, refine, copam, several graphtecs and a Roland and the copam was the first one that did fine detail relatively easy and then it was a major leap in cutting with the Roland and Graphtecs. One of the best I have had was an older graphtec FC4100 I bought for 149.00. cut incredibly well. I will upgrade to another fc sometime in the future Share this post Link to post Share on other sites
