Sign in to follow this  
machina

Updated firmware to 3.2 and now GPGL Error 1

Recommended Posts

Updated the fw on my CE5000 from 3.0 to 3.2 and now i get a GPGL Error 1

when the plotter turns on (after pressing roll 1 command)

Any ideas? Was working fine before.

dr

Share this post


Link to post
Share on other sites

not sure,  what cutting software are you cutting with?  Have you tried to put the machine back to DEFAULT factory setting,  by turning off your machine, And WHILE turning your machine back on,  holding down on the UP arrow button,  brings it back to factory default.

Share this post


Link to post
Share on other sites

Yes, reflashed it and did a reset with the up arrow.

Guess I will call Graphtec tomorrow.

The flash updates the firmware in the machine. I had 3.0 and was trying to go to 3.2, now i have a dead machine.

Anyway, i hope it is something simple.

dr

Share this post


Link to post
Share on other sites

reflash the firmware

I don't even know what that means,  please explain.   :huh:

It's a software routine that reprograms a chip with software on the mainboard that normally doesn't change. for improving functionality - like for new software or know bugs

Share this post


Link to post
Share on other sites

Well i am not sure what i did but now its up and running with fw 3.2

I unistalled and reinstalled vista driver and CM software and reinstalled plotter to system.

Anyway, thanks guys.

dr

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this