pyrophire 0 Posted August 3, 2010 Just got my CE5000-60 today.... I have signcut installed for my Refine871 and it works great with the graphtech, but I installed cuttingmater2 and the plugging for illy and when I sent a job to the cutter it gives me a HP-GL Error 1. Ive done a reset on the software and cutter and still have the same problem. I've done the reset that I found here and still nothing. Id like to use the cuttingmaster software and not just the signcut. Sorry for that run on statement. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 3, 2010 if you used the graphtec software at all it changed the cutter to GPGL and you have to change it back in the cutter menu Share this post Link to post Share on other sites
pyrophire 0 Posted August 3, 2010 I used cuttingmaster and signcut only, I'm on mac so I dont know what the graphtec software is... if there even is one for mac Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 3, 2010 Check int he menu on your cutter and make sure it is still set for hpgl - I will wager it has changed for some reason - it has given all of us a scare at one point or another Share this post Link to post Share on other sites
pyrophire 0 Posted August 3, 2010 I put it to GPGL and it worked lol Share this post Link to post Share on other sites