Sign in to follow this  
wnt4it

Com 6 keeps dropping off Output Device/Port menu

Recommended Posts

Good Morning .. ;D

  I'm using SignCut Pro for cutting with my CoPam 2500.  I just purchased/installed WinPCSIGN for working with Rhinestone designs/cutting templates.  I was able to cut from WinPcSign fine.  When I went back to SignCut the com 6 was gone.  Will I have to install the driver everytime I switch from the different software programs?

Also, I read a thread earlier about contour cutting with CoPam and wondered if anyone found a trick.  I'd like to figure something out for that as well.

Thanks for your time.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this