wnt4it 0 Posted August 1, 2010 Good Morning .. I'm using SignCut Pro for cutting with my CoPam 2500. I just purchased/installed WinPCSIGN for working with Rhinestone designs/cutting templates. I was able to cut from WinPcSign fine. When I went back to SignCut the com 6 was gone. Will I have to install the driver everytime I switch from the different software programs? Also, I read a thread earlier about contour cutting with CoPam and wondered if anyone found a trick. I'd like to figure something out for that as well. Thanks for your time. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted August 1, 2010 You can contour cut with Flexistarter8.6 with contour cutting. http://cgi.ebay.com/FlexiStarter-Contour-Cutting-Vinyl-Cutter-flexi-starter-/270615690652?cmd=ViewItem&pt=LH_DefaultDomain_0&hash=item3f01f3bd9c Share this post Link to post Share on other sites
wnt4it 0 Posted August 1, 2010 Thanks for the info....appreaciate your time. Share this post Link to post Share on other sites