Sign in to follow this  
Michelaua

How to ground MH-871

Recommended Posts

Sorry no pix but just run a wire from any screw on the cutter to any screw on the stand and you got it  :thumbsup:

MM64  :thumbsup:

Share this post


Link to post
Share on other sites

Not just any screw.  Check it with an ohm meter to make sure the screw you are using has continuity to the ground lug on the power cord.  I think all of the screws facing inward go to ground.

Share this post


Link to post
Share on other sites

why did mine come without the ground wire? 

I'm cutting a 50yds htv vinyl and a lot of the vinyl was damaged because of the static was producing from the huge roll

like 50% of the vinyl had to go to the garbage 

I placed a wire now its working fine 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this