Pcut cutting my parts the wrong size - Scale issue

[MikeOswald 0]

I was cutting (2) 5" x 24" long parts today out of 15" wide roll.    The length of the final part came out to be 23" and the width was like 4 7/8"

Does this adjustment sound like a cutter issue or a software issue. 

I use Artcut 09 for software.

On the Pcut LCD display I see there is a  "X Scale"  and "Y Scale"  Both were set to close to factory settings (I just purchase this machine used) and I have adjust each up to 300 in either direction, did not notice a big change.

Any ideas?

[Dakotagrafx 7,297]

This thread might help

http://forum.uscutter.com/index.php/topic,11751.0.html

[MikeOswald 0]

Wow, that is awesome!  I did a search and could not find anything.  I guess it is safe to assume the laserpoint and the pcut run the same controls.

I did adjust these numbers already and did not notice a change at all.  I will try again and let you know what happens.

[Dakotagrafx 7,297]

they are the same machine but the lp has a fixed laser to aid in manual contour cutting