Pcut ct630 Support wheel problem

[silvertrx 0]

The two support wheels that u can adjust to support the vinyl are leaving marks on my vinyl. they must be pushing down two hard on the vinyl.

Any ideas how to fix this?

Thanks

[MZ SKEETER 4,709]

that just goes along with the less expensive cutters,  they should go away when you apply the vinyl.  

[silvertrx 0]

i have nothing but problems with mine.

Sometimes it will cut for days without any real problems, then just out of the blue the cuts are terrible, cuts not joining etc...

Cant work out if its the pcut or the software (signblazer) as i always cut the same decals

Getting a bit sick

[Dakotagrafx 7,297]

that just goes along with the less expensive cutters,  they should go away when you apply the vinyl.  

true that

[jhelms 5]

reading some of your other post I dont know that you have your pcut dialed in just right try the newbie manual, and it will make tracking marks but once installed the marks will disappear good luck jhelms