tbenefi33 0 Posted July 17, 2010 Signcut started doing this. This is a tree that it drew and went at it at a angle then finished as you can see in the pic I'm stumped. Share this post Link to post Share on other sites
JoeCamaro 11 Posted July 17, 2010 1. Check the artwork in wireframe in the design software. 2. Reset machine. 3. Check static. Share this post Link to post Share on other sites
kyjeeper 1 Posted July 17, 2010 I agree with Joe. Looks like an unclosed path issue to me. Share this post Link to post Share on other sites
tbenefi33 0 Posted July 17, 2010 I have it grounded from the base of the screw and to the stand also was thinking a crazy I just recently got a memory up grade chip and it came in one of thoses static bag I was thinking of putting the static bag around where the cutter box think thight might help with some of the static or just a crazy ideal ? Share this post Link to post Share on other sites
kyjeeper 1 Posted July 17, 2010 I meant unclosed path as in the design. That's when I usually see this issue with flexi. Share this post Link to post Share on other sites
tbenefi33 0 Posted July 17, 2010 sorry you got me on unclose path as in the design ? Share this post Link to post Share on other sites
tbenefi33 0 Posted July 17, 2010 Checking that wire frame may have done the trick thank you. Its just finished a mirror image . Share this post Link to post Share on other sites
kyjeeper 1 Posted July 17, 2010 an open endpoint in the wireframe is what I meant by unclosed path. I'm used to using illustrator terms. Share this post Link to post Share on other sites
JoeCamaro 11 Posted July 17, 2010 I'm glad you solved it. I always check my designs in wireframe before cutting as it will show any imperfrctions. Share this post Link to post Share on other sites