Recommended Posts

anyone have the proper settings for all the options in the setup in signblazer i think kid has been playing with check marks and numeral settings in sb after year im getting bad jagged cuts ?

is it posible that i need a new blade holder after a year its the plastic one that come with the cutter and just in the last month iv been getting problems it seems to rip vinyl jagged cut not bad just noticable and im using 45 deg blades iv set the offset .25 in blazer and press is at 100 whats the deal dazed and confused about this all of a sudden crap cuts

Share this post


Link to post
Share on other sites

hey i think i have it going good but question somewhere i read a drop of oil on the blade holder is good now i got sewing mach. oil is that good and is there some other places on the mech that would need lube every now and again ?

Share this post


Link to post
Share on other sites

DON'T USE OIL on the bladeholder, use GRAPHITE, oil will dry and cause the blade to stick and not turn freely.

Joe

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this