blarsen 0 Posted June 12, 2010 I finally have gotten the right software so FlexiSTARTER is running nicely on my Mac book. However I can't get it to cut anything on my Plotter. I have set it up as a Roland PNC-1000 it sends it but the status just stays at holding. Any suggestions?? Share this post Link to post Share on other sites
Karl 0 Posted August 6, 2010 are you using a Keyspan adapter? uscutter should be bundling the keyspan with any cutter they sell "for mac" there is a major communication problem that is easily overcome by putting a Keyspan between the computer and the cutter. Share this post Link to post Share on other sites