stormy

WINDOWS 7 AND MH721 USB WONT WORK!!

Recommended Posts

Had this cutter for years. Works fine on my Vista. Trying to switch it to my Windows 7 laptop as my vista desk isnt being too reliable lately.

When I plug it in it says USB not recognized. Tried everything. Can't find driver. Driver installed correctly. blah blah blah.

Ben took control of my computer and tried his magic for about 30 minutes and still no luck!

Any suggestions?

Share this post


Link to post
Share on other sites

ok the usb to serial installed correctly and everything, but it won't cut when i send to cutter....................

Share this post


Link to post
Share on other sites

I had to download the prolific driver for the usb/serial cable on mine. But after that I had no problems at all.

Share this post


Link to post
Share on other sites

where do you get the profilic driver? and does anyone know where to get a usb to serial for cheaper than $35?

Share this post


Link to post
Share on other sites

hmmm....contemplating whether I should go back and get that cable that I returned already......

think there's a good chance that's why signcut wouldnt cut? It showed up as a COM5 when I installed it and set it under that so all looked good. Just didnt work.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now