Sign in to follow this  
mr_signs

Signcut Makes Multiple Passes

Recommended Posts

Hello Everyone,

Hoping someone on here can help me out...

Signcut makes 2-3 passes over the same cut even though I have it set to only make 1 pass.  Not sure what i am doing wrong if anything.  I was able to reduce the number of nodes the vectorized image had so I don't think thats the problem.  Any help would be appreciated!

Here's my setup:

Macbook OSx 10.5.8

Signcut Pro w/Mac Build 1.07

AI CS4

Maybe the trace option in AI is causing this? :-[  I just need it to stop after the first pass and move on to the next, you know...lol!

Thanks!

Share this post


Link to post
Share on other sites

sounds like there is more than one image on top

it happens - ungroup it then drag apart - you prob will find there is more than one cutting line on top of each other

Share this post


Link to post
Share on other sites

Right on! +1

Remember the first time that happened to me, took forever and a lot of vinyl to figure that out. But I didn't know about this forum then either :-[

Share this post


Link to post
Share on other sites

sounds like there is more than one image on top

it happens - ungroup it then drag apart - you prob will find there is more than one cutting line on top of each other

Awesome I will try that out!! That would do it.  I'll post how that goes tomorrow...

Thanks again!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this