jhocksrule 0 Posted March 11, 2010 This is a fun window decal I was asked to make for some friends that are in a boat club. They like to have a good time. Let me know what ya think. Selling them for $5. I think thats pretty reasonable. Some of the corners of the letters sometimes snag, or seem a little jagged. Any suggestions? Share this post Link to post Share on other sites
tlzimmerman 11 Posted March 11, 2010 As far as corners snaggin and being jagged.......check the offset of the blade in the cutter software. What cutter are you using? What software? As a fellow Jayhawk fan...Rock Chalk baby! Share this post Link to post Share on other sites
jhocksrule 0 Posted March 11, 2010 Creation P-Cut. Signblazer for the software. What should my offset setting be set at? ROCK CHALK!!! Share this post Link to post Share on other sites
tlzimmerman 11 Posted March 11, 2010 depends on the blade you are using...most 45 degree blades it should be .25mm Share this post Link to post Share on other sites
MacGrafix 5 Posted March 11, 2010 what about 60deg blades? Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted March 11, 2010 Nice work 8) Dan Share this post Link to post Share on other sites
Guest kenya Posted March 11, 2010 That one is always a fun decal to make. Looks good. Share this post Link to post Share on other sites
Dale 0 Posted March 12, 2010 I had that same one on my first car. Wow, still around! lol Share this post Link to post Share on other sites
MikeMan 0 Posted March 12, 2010 what about 60deg blades? .15mm Share this post Link to post Share on other sites
